Identification Data; Installation; Important Information For The Installer; Standard Assembly Kit - Danfoss OPTYMA Control AK-RC 101 Operation And Maintenance Manual

Identification data

The unit described in this manual has an ID label on
the side showing all the relevant identification data:
• Name of Manufacturer
• Type and code number
• Product name
• Power supply
• Serial number (10 digits)
• Date (Day/Month/Year)

Installation

Important information for the installer.

Installation to be done by authorised person only!
1. Install the device in places where the protection
rating is observed and try not to damage the
housing when drilling holes for wire penetrations
2. Do not use multi-polar cables which have
wires connected to inductive/power loads and
signalling wires (e.g. sensors and digital inputs).
3. Do not fit power supply wiring and signal wiring
(sensors and digital inputs) in the same
raceways or ducts.
4. Minimise the length of connector wires so that
wiring does not twist into a spiral shape as this
could have a detrimental effect on the electronics.

Standard assembly kit

For the purposes of assembly and use, the electronic
OPTYMA Control single-phase unit comes with:
TM
• Three rubber washers, to be fitted between the
fixing screws and the housing back panel
• One user's manual.
• Two temperature sensors
4
5. Fit a general protection fuse before the electronic
6. All wiring must be of a diameter suitable for
7. If a sensor extension is required, the wires
8. If data communication is used, it is important
9. If data communication is used, the alarm relay
RS8FD402 © Danfoss A/S 2014/11
controller.
relevant power levels.
must have a diameter of at least 1 mm
that the data communication cable is correctly
installed. See separate literature, no. RC8AC...
cannot be used.
OPTYMA
.
2
Control single-phase AK-RC 101
TM