Installing The Unit - Danfoss OPTYMA Control AK-RC 101 Operation And Maintenance Manual

Installing the unit

1.
Lift the transparent cover.
Remove the screw cover on the
right-hand side of the housing.
2.
Undo the 4 fixing screws at the
front of the housing.
3.
Open the front of the housing, lift
it and slide the two hinges out as
far as they will go.
4.
Press on the sides of the hinges
to remove them from their seats
and then remove the front panel
completely.
OPTYMA Control single-phase AK-RC 101
TM
RS8FD402 © Danfoss A/S 2014/11
5