Hellenbrand ProMate 1 Owner's Manual page 13

STEP 8D
Press and hold  and  buttons for 3 seconds while in Step 8D
to reset the MAV drive history in both the retracted and extended
piston rod position. To view the old MAV drive history data for
retracted and extended rod position press and hold SET CLOCK
and  while in Step 8D. Press NEXT to advance display to the
old MAV drive history.
STEP 9D
RETURN TO NORMAL MODE
When desired, all programming and all information in Diagnostics may be reset to defaults when the valve is installed in a
new location. To reset to defaults, press NEXT and  simultaneously to go to the Softening/Filtering screen. Press  and 
simultaneously to reset diagnostic values and all programming to defaults. Screen will return to User Display.
13
in 1/100 of a second; i.e., a 17.10 second move is displayed as 1710. Press NEXT at any time to go to
Step 9D. Press REGEN to return to previous step.
a second; i.e., a 17.15 second move is displayed as 1715. Press and hold  and  for 3 seconds
while in Step 9D to reset the MAV drive history in both the extended and retracted piston rod
position. To view the old MAV drive history data see Step 8D. Press the NEXT button at any time
exit Diagnostics. Press REGEN to return to previous step.
STEP 8D – MAV Drive History in the direction of extended piston
rod position. Display will not be shown if 1.0T is not selected in
Step 2CS or OFF is selected in Step 4CS. If the display does ap-
pear up to a four digit number will appear after the "L" which stands
for latest and "A" which stands for average. Drive time is measured
STEP 9D – MAV Drive History in the direction of retracted piston rod
position. Display will not be shown if 1.0T is not selected in Step
2CS or OFF is selected in Step 4CS. If the display does appear, up
to a four digit number will appear after the "L" which stands for latest
and "A" which stands for average. Drive time is measured in 1/100 of