Warnings - Omegasonics 7850TT Operation & Instruction Manual

Failure to read these warnings may cause the unit to fail, personal injury or property
damage.

Connect the unit to a grounded shockproof socket only. Ensure that the values indicated
on the nameplate of the unit must correspond with the available connecting conditions.
The unit must be connected to a single phase, 120 volt AC grounded electrical outlet.

Check the ultrasonic unit for possible transport damages before initial operation.

In case of visible damage do not connect the unit to a power source, contact your
supplier.

Do not use this machine for cleaning live animals, pets or plants.
 Do not plug equipment into a power source that utilizes a GFI receptacle. Ultrasound
passes a small, trickle current through the neutral which will cause GFI's to trip.
 Never plug in or operate the unit (heat or ultrasound) without the appropriate liquid
level in the tank (1" from the top).

This ultrasonic cleaning unit has been designed for cleaning items using liquid soap
only.
 Any detergents or chemicals used in this equipment must be compatible with 300 series
stainless steel. Do not use any chemicals that contain any strong acids i.e. hydrochloric,
sulfuric or muriatic acid. These chemicals will cause permanent damage to the stainless
steel welds.
 Use only biodegradable cleaning agents. Never use solvents or flammable cleaning
solvents without approval from Omegasonics. Any chemistry with a flash point below
82˚C should never be used with an ultrasonic cleaner.

Ensure that sensitive surfaces are exposed to ultrasonic activity for short periods of time
only. If in doubt check the cleaning progress regularly and observe the state of the
surface material.
 Due to the heated liquid in the tank, use the basket to insert or remove parts from the
tank. Always switch off the unit when placing items in or taking them out of the tank.
 Do not operate the unit with wet hands.
 Do not open the internal circuitry of the equipment, disassemble any part or parts, or
move or remove any components or electrical devices.
 Never attempt to perform maintenance on the equipment when the unit is energized or
when the cleaning solution is hot. The cleaning liquid and unit heat-up even if heat is
switched off.
 Disconnect the power source when moving the unit to a new location.
 Avoid splashing water outside the tank.
The manufacturer cannot be held liable for damages of persons, equipment or items cleaned caused
by improper use. Only qualified technically trained personnel should perform any electrical
maintenance on this machine.

WARNINGS

4