Omegasonics 7850TT Operation & Instruction Manual page 11

Firearms
 In the ultrasonic bath, preheat 1 part OmegaBlue with 32 parts clean water to a
temperature of 46˚C.
 Disassemble the firearm into its major components. If it is equipped with a scope, it can
be left attached.
 Spray the components with a spray bottle containing 1 part OmegaBlue, 21 parts clean
water solution. Let sit for 1 – 3 minutes.
 Rinse off the residue loosened by the solution.
 If the stock is synthetic, it can be cleaned with the other metal parts. If it is wooden, use
a basket to submerge it into the bath and clean for 1 -2 minutes.
 Using a basket, submerge the components into the bath and clean for 1 – 5 minutes,
until all residues are removed.
 You may spot clean using the spray bottle solution and a 3M pad that is green or light in
color.
 Rinse all components with de-ionized water that is 46 - 49˚C.
 Blow off excess moisture with compressed air and dry using a hand-held hot air dryer.
 Lubricate using light gun oil or silicone spray.
 Test using industry standards.
Bicycle Parts
 In the ultrasonic bath, preheat 1 part OmegaSupreme with 10 parts clean water to a
temperature of 60˚C for aluminum, or 66˚C for chains, derailleurs and gears.
 Place the items into the basket with the cavity containing heaviest residue facing the
bottom of the basket.
 Clean the part(s) for 5 minutes.
 Once completed, rotate the part 180˚ if the part facing opposite the ultrasonic
transducers is heavily soiled.
 If necessary, clean the part for an additional 5 minutes.
 Once the part is cleaned, remove from the bath and rinse using hot water.
 Blow off the excess water using compressed air.
 Due to the heat of the metal, after being removed from the bath, it will dry quickly, on
its own ("flash dry").
 Note: If your aluminum parts develop any type of scarring or starbursts on the surface,
lower the bath temperature to 54˚C.
11