Set Up; Cleaning - Omegasonics 7850TT Operation & Instruction Manual

•
Place the unit on a dry and solid surface.
•
Ensure that the workplace is sufficiently ventilated.
•
Do not use a soft surface (i.e. carpet) as this may impede the ventilation of the unit.
•
Operation should only occur indoors.
•
Close the drain valve before filling the tank (turn the drain knob on the tank to the
horizontal position).
•
Fill the cleaning tank with a sufficient quantity of a suitable cleaning liquid and water
before turning-on the unit.
•
The marked maximum filling level of the tank indicates the recommended filling level
with items to be cleaned in the tank.
•
To quickly heat up the liquid in the tank and to prevent unnecessary energy losses, we
recommend use of the lid.
•
Do not exceed a temperature of 80°C inside the tank.
Timed
 Select the required temperature.
 Set the required ultrasonic cleaning period.
 When the set cleaning period has run down, the ultrasonic activity switches off
automatically. The heating continues operating at the set temperature.
Continuous
 For permanent operation turn the turning knob clockwise into "ON" position. In this
operating mode there is no automatic switch-off. The ultrasonic activity must be
switched off by hand. After the cleaning process has been finished, press the
switch off. Alternatively, turn the knob back into "Off" position.
 In order to avoid unintended permanent operation, the Omegasonics units are
equipped with a safety switch-off automatically. The unit switches off completely after 8
hours of permanent operation. If you wish to continue the operation, start the unit
again.
SET-UP

CLEANING

key to
8