Omegasonics 7850TT Operation & Instruction Manual page 17

CLEANING AGENTS - OMEGASONICS
Omegasonics carries a full line of cleaning agents. Each cleaning agent has a
unique cleaning specialty and use. Some of the products are as follows.
 OmegaSupreme – Heavy-duty degreaser removes carbon, oil, dirt, grease and
dirt from a variety of metals. It is excellent for cleaning and brightening ferrous
and nonferrous metals. Product may cause aluminum to scar if left in contact
with aluminum part for an extended period of time. Product contains a short-term
flash rust inhibitor.
 OmegaClean – General to heavy-duty degreaser which will remove carbon, oil,
grease and dirt from a variety of metals and will not harm aluminum finishes.
Especially formulated for the aerospace industry as well as for automotive
applications. Has built in conditioners for hard water (high calcium and
magnesium content) sources and good quality rust inhibitors.
 OmegaZyme – Ideal for industrial applications cleaning oil and grease from
aluminum, stainless steel and titanium parts. Does not remove carbon. Will
cause cast iron and cold rolled steel parts to rust if not used in conjunction with
silicate, nitrate or trisodium phosphate rust inhibitors or with another cleaning
agent containing rust inhibitors.
 OmegaCitriSurf 2250– Designed for industrial and aerospace applications
where stainless steel passivation (the removing of free iron from the surface) is
required. Also useful in removing calcium deposits from a variety of metals
including brass and steel.
 Omega DeScaler - A unique product formulated to remove rust, corrosion, heat
scale and mineral deposits from a variety of metals. Excellent when used in an
ultrasonic tank to remove rust from metal components exposed to extreme
moisture and water. Effectively used to remove mineral deposits from heat
exchangers
 Omega Mold Release - A high pH concentrated cleaning agent used
successfully to remove burnt-on crystalline rubber, plastic and food from molds,
dies and other metal surfaces
 OmegaBlue - Designed to remove ink and ink residue from metal and rubber
components including Anilox rollers.
 Omega Aqua Clean LPH – A reduced pH solution designed to clean electronic
and electrical components. Also effective at removing solder flux residue. It is
safe on all surfaces that can be cleaned in water and any surfaces that may be
damaged in a high pH solution.
The above products are concentrates. These products are formulated to be used at
a 10 to 1 ratio. Ten 10 parts water one part cleaning detergent
17