Push Button Ignition System Connection Diagrams - Warming Trends CFB60 NG Owner's Manual And Instruction Manual

PUSH BUTTON IGNITION SYSTEM
CONNECTION DIAGRAMS
Up to 300K BTU Systems
1. Install Push Button Module
into Mountin Bracket
Unscrew Button Cover.
Remove plastic Nut.
Insert Washer #1.
Insert Washer #1 onto the
button stem.
Insert Push Button Stem
2. Install Push Button Module
into Mountin Bracket
Unscrew Button Cover.
Remove plastic Nut.
Insert Washer #1.
Insert Washer #1 onto the
button stem.
Insert Push Button Stem
through mounting bracket
hole.
Insert Washer #2.
Put on plastic Nut and turn
until Push Button Control has
been secured to mountin
bracket.
Insert AA Battery into Button
Stem.
Screw on Button Cover.
3. Connect Spark Igniter Wires
Crimp Spark Igniter Wires,
then slide crimped wires on
to connections using needle
nose pliers. Be careful not to
break connectors. Wires can
go in either connection.
4. Test without Gas
Test Spark Igniter and Push
Button Module WITHOUT gas,
making sure spark arcs from
electricity to jet.
5. Test with Gas
Burner should light within 5
seconds or a few clicks.
Drill Here
Push Button
Module
Button Stem
Washer #1
Washer #2
AAA Battery
Button Cover
Spark Igniter
Wires
Push Button
Module
www.Warming-Trends.com | 303 346 2224 | orders@warming-trends.com
.125"
Jet
Nut
CROSSFIRE
Brass Burner
Plate
Key Valve
Mounting Bracket
Key Valve
Mounting Bracket
19