Start The Printer; Power-On And Self-Test; Mark Calibration - TVS LP 46 NEO User Manual

cable when the power has not been turned off.

2.6 Start the printer

2.6.1 Power-on and self-test

1) Ensure the power adapter and the communication cable are
connected correctly, and turn on the printer;
2) The printer starts the self-test. The buzzer beeps once for a short
time after the self-test is finished, and then the LED displays
green and it is always on;
3) If power-on action is set, the printer will perform power-on action.
Note: Power-on action refers to the actions performed automatically
after the printer is turned on, including feeding one label,
starting
discontinuous paper mode). The power-on action can be set
by commands or configuration tools.
Caution:
If the printer can not be started or can not work normally after it
is started, please contact SNBC or local dealer in time.

2.6.2 Mark calibration

1) Firstly, install the print medium correctly, and then turn on the
printer;
2) After the printer finishes the self-test, it will enter standby mode.
Keep pressing the button and release it after the power LED
has flashed two times. Then the printer will start feeding paper
and start calibration;
calibration automatically
LP 46 Neo User's Manual
- 11 -
(only valid under