TVS LP 46 NEO User Manual page 14

2) Lead he front end of ribbon go through under the print head
module and wind it around the rewinding shaft of ribbon;
3) Install the rewinding shaft of ribbon onto the ribbon holder
according to the method in step 1);
4) Push the ribbon thumb wheel to tighten the ribbon (installed
paper roll and ribbon refer to figure 2.3.2);
5) Press down the ribbon holder to locking status, then close the
Figure 2.3.3
Figure 2.3.2
LP 46 Neo User's Manual
Figure 2.3.3
- 9 -