TVS LP 46 NEO User Manual page 13

inch), insert the ribbon core shaft into the ribbon and the
empty ribbon shaft separately (see Figure 2.3.2). And the
following operation is the same as in the step A).
Rotate the ribbon holder to the position shown in Fig. 1, then
insert the assembled ribbon module into the ribbon end cap in
the direction shown in Figure 2 and insert the other end of
ribbon into the ribbon thumb wheel, and then pull the ribbon
outward slightly until you feel an elastic retraction force which
indicates that the installation of ribbon on releasing shaft is
complete (see Figure 2.3.3);
Figure 2.3.2
- 8 -
LP 46 Neo User's Manual