Phone Setup; Ways To Provide Power To Your Conference Phone; New And Changed Information For Firmware Release 12.0(1)Sr2 - Cisco 8832 User Manual

Your Phone
Revision
Support for Cisco IP Conference Phone
8832 Non-PoE Ethernet Injector
Support for Wi-Fi
Support for Mobile and Remote Access
Through Expressway
Support for CMC and FAC

New and Changed Information for Firmware Release 12.0(1)SR2

The following table describes changes to the Cisco IP Conference Phone 8832 User Guide to support Firmware
Release 12.0(1)SR2.
Revision
Updated for Cisco IP
Conference Phone 8832 PoE
Injector support

Phone Setup

Typically, your administrator sets up your phone and connects it to the network. If your phone is not set up
and connected, contact your administrator for instructions.

Ways to Provide Power to Your Conference Phone

Your conference phone needs power from one of these sources:
• Power over Ethernet (PoE)
New or Updated Section
•
•
• North America
• Cisco IP Conference Phone 8832 PoE Injector
• Cisco IP Conference Phone 8832 Ethernet Injector
• Outside of North America—Cisco IP Conference Phone 8832 PoE Injector
New and Changed Information for Firmware Release 12.0(1)SR2
New or Updated Section
• Ways to Provide Power to Your Conference Phone, on page
3
• Connect to the Network, on page 5
• Ways to Provide Power to Your Conference Phone, on page
3
• Connect to the Network, on page 5
• Set Up Wi-Fi Client, on page 6
• Connect to a Preconfigured Wi-Fi Network, on page 6
• Connect to the Network, on page 5
• Connect to Expressway, on page 7
Calls That Require a Billing Code or Authorization Code
Ways to Provide Power to Your Conference Phone, on page 3
Connect to the Network, on page 5
Cisco IP Conference Phone 8832 User Guide
3