Using The Cd/Mp3 Player - Omnitronic MOM-10BT4 User Manual

Using the CD/MP3 player

The player accepts standard audio CDs and CDs, USB storage devices and SD cards with MP3, WMA and
WAV files. The player can either be operated via the buttons on the front panel or via the remote control.
1) Switch on the Bluetooth receiver by turning the PLAYER/BT control from the left stop position. Then
shortly press the POWER/MODE at the player.
2) After loading a data carrier, it is selected as the playback medium. Shortly press the POWER/MODE
button to switch between the data carriers. The selected medium is shown on the display. If a data
carrier is not recognized at the first try, remove it and insert it again.
3) Press the [► ] button, to start playback (insertion ► ) . . To interrupt the playback, press the button once
again (insertion ) . .
4) Use the VOL- and VOL+ buttons to adjust the basic volume level of the player. Then mix the player's
signal to the master signal with the PLAYER/BT level control. To mute the player, press the [
(insertion MUTE).
5) By short actuation of the buttons [
-10
the buttons [ ] and [
6) Use the [SEL] on the remote control to select sound settings: Bass
Loudness. Use the [VOL-] and [VOL+] buttons to adjust the values.
7) Short repeated actuation of the button [EQ] on the remote control selects equalizer settings: Rock
Classic DSP off, the [LOUD] button actives a loudness feature.
8) With the [RPT] button on the remote control, you can activate repeat functions: 1
9) With the [RDM] button on the remote control, you can activate random play.
Notes
• Folders will be combined for playback. There is no folder navigation available.
• Prior to removing a data carrier, always terminate the playback with the buttons [►II]. Otherwise damage
or loss of data may occur.
• The PLAYER/BT control will also apply to the Bluetooth receiver. Therefore, do not use the Bluetooth
receiver during CD player operation. Otherwise, both audio sources will be reproduced at the same time.
• To prevent unnecessary power consumption, always switch off the CD player with the PLAYER/BT control
if the player is not used.
• The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote
control is not possible.
• If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the
right and at the same time remove the battery support. If the remote control is not
used for a longer period, please remove the batteries to prevent damage in case of
battery leakage.
] and [
+10
] on the remote control to jump 10 titles forward or backward.
] you can skip titles in forward or backward direction. Use
41 • EN
] button
Treble Balance
ALL OFF.
EQ
Pop