Omnitronic MOM-10BT4 User Manual page 31

No. Element
1 CD/MP3 player
2 Receiver modules
3 Audio link module
4 Antenna input
5 Pairing switch
6 Bluetooth indicator
7 Level control
8 Tone control
9 Effect control
10 Level control
11 On/off switch and level
control
12 Tone controls
13 Microphone inputs
14 Line input
15 Sliding switch
16 Link output
17 Sliding switch
18 Master control
19 Fuse holder
20 Power input
21 Charging indicators
22 Voice priority switch
23 Power switch
24 USB charging port
Function
Insertion module with remote control for retrofitting.
Insertion modules for wireless audio transmission (16 channels in the
UHF ranges 823-832 and 863-865 MHz) with matching transmitters of
the MOM-10BT4 series.
Insertion module for retrofitting; for wireless operation of several
MOM-10BT4 systems. Via the audio link module, the master signal of the
primary system can be transferred to the receiving modules of further
systems.
Common BNC jack for receiver modules.
Switches the paring mode of the built-in Bluetooth receiver on and off.
Flashes in pairing mode and lights continuously when the connection to
the Bluetooth source is established.
To mix the microphone signal of the corresponding MIC IN input to the
master signal.
Adjusts the sound for the microphone inputs. In the left half the high
range is attenuated, in the right half the low range is attenuated.
Adjusts the intensity of the internal reverb effect for the microphone
inputs.
To mix the line signal of the LINE IN jacks to the master signal.
Common power switch and level control for the Bluetooth receiver and
the CD/MP3 player.
2-band tone control for the master signal (BASS = low frequencies,
TREBLE = high frequencies).
Combined jacks (6.3
microphones.
XLR jack and stereo RCA jacks for connecting devices with line level
(e.g. CD player).
Switches the signal for the line input between stereo and mono source.
XLR jack to feed the mixed signal of all audio and wireless sources to
devices with line level inputs, e.g. another PA system.
Selects the signal for the XLR link output (16) and the audio link module.
• STEREO MIX: The master signal is available as mono signal.
• MONO R: The right stereo signal of the master signal is available.
Adjusts the overall volume.
Only replace the fuse when the device is disconnected from mains. Only
use fuses of the same rating and power.
Used to plug in the supplied power cord.
Indicate the status for the rechargeable batteries. If the LOW LED lights
up red, the batteries should be charged. During mains operation the
LEDs are flashing when the batteries are being charged.
Switches the microphone priority function on, i.e. the volume of the other
audio sources will be substantially reduced during microphone
announcements.
Switches the PA system on and off.
To charge the batteries of mobile devices up to max. 5V/2 A.
31 • EN
mm jacks/XLR) for connecting dynamic