Inst Id Key; Output On Key; Connectors - Tektronix PFG 5505 Instruction Manual

@
I NST I D KEY
Causes the PFG 5105/5505 to display its GPIB ad­
dress, EOI/LF terminator and, if enabled, to generate
a service request (SRQ) over the GPIB. To display
the GPIB address or terminator, press INST ID. To
change the address, enter SPCL function code 240,
and press ENTER; press the INCREMENT up- or
down-arrow key to change the displayed address to
the new address, or enter the new address using the
DATA keys; press ENTER. To change the terminator,
enter SPCL function code 241 and press ENTER ; use
the INCREMENT up- and down-arrow keys to change
the displayed terminator selection, press ENTER to
set the selection.
@

OUTPUT ON KEY

Turns the main output of the instrument on (LED on)
or off.
PF G 51 05/5505 Instruction Manual
@
CON NECTORS
Refer to the specifications in Section 1 for input/
output characteristics and limits.
T RIG IN The input connector for external TT L­
level trigger and gate functions.
SYNC
The output depends on the function set.
OUT In the standard modes, the output is a
TTL square wave in phase with the main
output and at the same frequency as
the main output.
SWEEP Outputs a sweep control voltage for use
OUT
with an xy oscilloscope or plotter.
V CO/FM
The input connector for the FM modula­
tion signal or the V CO input voltage.
I N
The input connector for the AM modula­
A M I N
tion signal.
OUTPUT The output connector for the main gen­
erator signal.
Operating Instructions
2 -9