Danfoss VLT PROFIBUS DP MCA 101 Programming Manual page 46

Parameters
9-71 Profibus Save Data Values
Option:
[0] Off
*
[1] Store all
setups
6 6
[2] Store all
setups
9-72 ProfibusDriveReset
Option:
[0] No action
*
[1] Power-on
reset
[3] Comm
option
reset
9-80 Defined Parameters (1)
Array [116]
No LCP access
Read only
Range:
0 [0 - 9999 ] This parameter shows a list of all the defined
*
9-81 Defined Parameters (2)
Array [116]
No LCP access
Read only
Range:
0 [0 - 9999 ] This parameter shows a list of all the defined
*
44
VLT
Function:
Parameter values changed via PROFIBUS are not
automatically stored in non-volatile memory.
Use this parameter to activate a function that
stores parameter values in the EEPROM non-
volatile memory, so changed parameter values
are retained at power-down.
Deactivates the non-volatile storage function.
Stores all parameter values for all set-ups in the
non-volatile memory. When all parameter values
have been stored, the selection returns to [0]
Off.
Stores all parameter values for all set-ups in the
non-volatile memory. When all parameter values
have been stored, the selection returns to [0]
Off.
Function:
Resets the frequency converter after power-up,
as for power-cycle.
®
Resets the VLT PROFIBUS DP MCA 101 option
only. This is useful after changing certain
settings in parameter group 9-** PROFIBUS, for
example, parameter 9-18 Node Address.
When reset, the frequency converter disappears
from the fieldbus, which may cause a
communication error from the master.
Function:
frequency converter parameters available for
PROFIBUS.
Function:
frequency converter parameters available for
PROFIBUS.
Danfoss A/S © 01/2016 All rights reserved.
®
PROFIBUS DP MCA 101
9-82 Defined Parameters (3)
Array [116]
No LCP access
Read only
Range:
0 [0 - 9999 ] This parameter shows a list of all the defined
*
9-83 Defined Parameters (4)
Array [116]
No LCP access
Read only
Range:
0 [0 - 9999 ] This parameter shows a list of all the defined
*
9-90 Changed Parameters (1)
Array [116]
No LCP access
Read only
Range:
0 [0 - 9999 ] This parameter shows a list of all the frequency
*
9-91 Changed Parameters (2)
Array [116]
No LCP access
Read only
Range:
0 [0 - 9999 ] This parameter shows a list of all the frequency
*
9-92 Changed Parameters (3)
Array [116]
No LCP access
Read only
Range:
0 [0 - 9999 ] This parameter shows a list of all the frequency
*
9-93 Changed Parameters (4)
Range:
0 [0 - 9999 ] This parameter shows a list of all the frequency
*
Function:
frequency converter parameters available for
PROFIBUS.
Function:
frequency converter parameters available for
PROFIBUS.
Function:
converter parameters deviating from default
setting.
Function:
converter parameters deviating from default
setting.
Function:
converter parameters deviating from default
setting.
Function:
converter parameters deviating from default
setting.
MG37G202