Suzuki DF70A Owner's Manual page 40

2. Make sure that the warm-up lever is in the
fully closed position.
3. (1) Confirm that the key-fob is in communi-
cation ON mode (Refer to the "Switching
the Communication mode of the key-fob"
section.)
(2) While the key-fob is within the communi-
cation range of the keyless control unit,
turn the main switch to the "ON & OFF"
position and then release it. The main
switch automatically returns to the
"PUSH START/STOP" position.
The buzzer sounds twice to notify that
the Keyless Start System has been
turned ON.
NOTE:
If equipped with Dual Engine:
When either one of the engines of Keyless Start
System is turned ON, another engine will auto-
matically be turned ON.
PUSH
START
ON & OFF
STOP
NOTE:
The communication range is a distance of 1 m
(39.4) between the key-fob and the keyless
control unit.
If the Keyless Start System fails to turn ON, the
buzzer emits one (1) long sound and five (5)
short sounds.
In this case, repeat the procedure again.
40
PUSH
START
ON & OFF
STOP
4. Push the main switch to start the engine.
NOTE:
By pressing the main switch once, the starter
motor turns for 4 seconds continuously until the
engine starts.
NOTICE
If you hold in the main switch to start the
engine, the starter system can be damaged.
Push the main switch and release it to start
the engine. The engine will crank continu-
ously for 4 seconds or until the engine starts.
NOTE:
The continuous operating time of the starter
motor is set at five seconds.
When this time is exceeded, the starter motor
will automatically stop.
If the motor stops, wait about ten seconds for
the motor to cool down and try again.
NOTICE
If the OIL lamp remains lit while operating the
outboard, the oil level may be low enough to
damage the engine.
Stop the engine and check the oil level.