Suzuki DF70A Owner's Manual page 17

3. Insert a flat blade screwdriver into the slot at
the mark on the cover to remove the bat-
tery.
4. Replace the battery so its + terminal faces
the cover side as shown in the illustration.
Lithium disc type battery: CR2025 or equiva-
lent.
Confirm that the O-ring is placed in position
on the body side.
5. Reinstall the cover.
SETTING AND/OR CHANGING THE PASS-
CODE
By setting a 4-digit passcode, the engine can
be started by entering the passcode even if the
key-fob battery has run down or the key-fob is
lost.
The same method is used to set and change
the passcode.
NOTE:
Carry the passcode with the emergency key in
case the key-fob battery runs down or the key-
fob is lost.
NOTE:
When the passcode has been updated or
changed, the previous passcode is deleted and
updated to the new passcode.
Use the following procedure to set or change
the passcode:
1. Confirm the engine is stopped.
2. Make sure the emergency switch lock plate
is in place.
3. Confirm the key-fob is within the communi-
cation range of the Keyless Start System.
4. Confirm that the key-fob is in communication
ON mode. (Refer to "Switching the commu-
nication mode of the key-fob" section.)
5. Turn the main switch to the "ON & OFF"
position and then release it. The main switch
automatically returns to the "PUSH START/
STOP" position.
The buzzer on the engine control side emits
one (1) long sound while the buzzer on the
keyless control unit side emits two (2) short
sounds simultaneously.
PUSH
START
ON & OFF
STOP
PUSH
START
ON & OFF
STOP
17