In this section:
Resistivity calculations ............................................................. 3-1
Calculating resistivity ................................................................ 3-1
Resistivity nomographs ............................................................ 3-4
Resistivity equations ................................................................ 3-6
Resistivity calculations
For instruments that do not directly measure resistivity, this section provides the equations needed to
calculate volume and surface resistivity using the applied test voltage and the measured current. If
accuracy is not needed, nomographs can be used to approximate resistivity. This section also shows
how to derive the equations used to calculate resistivity.
Calculating resistivity
The following equations are used to calculate volume and surface resistivity. They are based on the
physical dimensions of the electrodes of the 8009. For more information on how these equations are
derived, see
Derivation of resistivity equations
Derivation of resistivity equations
(on page 3-1).
Section 3