Important Notes; Remarks Concerning Emc; Fcc-Note; Cables - IMC CRONOSflex Getting Started

58 Attachment

5.3.4 Important notes

5.3.4.1 Remarks Concerning EMC

imc CRONOSflex satisfies the EMC requirements for unrestricted use in industrial settings.
Any additional devices connected to imc CRONOSflex must satisfy the EMC requirements as specified by
the responsible authority (within Europe2) in Germany the BNetzA - "Bundesnetzagentur" (formerly
BMPT-Vfg. No. 1046/84 or No. 243/91) or EC Guidelines 2004/108/EEC. All products which satisfy these
requirements must be appropriately marked by the manufacturer or display the CE certification marking.
Products not satisfying these requirements may only be used with special approval of the regulating
body in the country where operated. All signal lines connected to imc CRONOSflex must be shielded and
the shielding must be grounded.
2
If you are located outside Europe, please refer the appropriate EMC standards used in the country of operation.
Note
The EMC tests were carried out using shielded and grounded input and output cables with the
exception of the power cord. Observe this condition when designing your experiment to ensure
high interference immunity and low jamming.

5.3.4.2 FCC-Note

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules (CFR 15.105)3. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment on and off, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio or television technician for help.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device that are
not expressly approved by imc may void the user's authority to operate this equipment.
3
FCC - United States Federal Communications Commission

5.3.4.3 Cables

Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods to
maintain compliance with FCC Rules and Regulations.

5.3.4.4 Industrial Safety

We certify that imc CRONOSflex in all product configuration options corresponding to this
documentation conforms to the directives in the accident prevention regulations in "Electric Installations
and Industrial Equipment" (BGV-A3 of the Index of Accident Prevention Regulations of the Professional
Guilds in Germany).
imc CRONOSflex Getting Started Version 1.8 - 08.01.2014