Advertisement
OmniTour Guiding System OTG‐200
Troubleshooting
NO DATA shows up on transmitter
This screen might show up on transmitter and it means no prior pairing was completed. Please
pairing before requested operation is done.
NOT APPLICABLE shows up on transmitter
This screen might show up on transmitter and it means the function is not applicable.
BUSY shows up on transmitter
This screen might show up on transmitter and it means the talk right is occupied, please ask
that occupied transmitter/receiver to release this talk right.
DATA ERROR shows up on transmitter or receiver
Transmitter
Pairing data fails to acquire. Please turn the transmitter off and re‐turn it on again for successful
acquirement of pairing data. Note same communication mode and channel need to be set on
both transmitters (if the communication mode is "Teaching", the master/slave switch (
both transmitters needs to be tuned at "m").
Receiver
Pairing fails to complete. Please turn the receiver off and re‐turn it on again for successful
pairing.
Receiver can't hear Transmitter
Make sure the volume control (○
Make sure the channel number on both transmitter and receiver is same.
Make sure the "communication mode" (G , T or D) shown on both transmitter and receiver is
same.
Receiver can't talk back via PTT button
If the receiver is set at G UIDING mode, make sure master transmitter is tuned its master/slave
switch (○
) from "m" to "s" and no other receiver occupies the talk right.
10
) is tuned at appropriate level.
14
19
○
) on
10
Hide quick links:
Advertisement
