Advertisement
OmniTour Guiding System OTG‐200
for 5 seconds for auto‐confirmation.
Channel number stops flashing. Signal indicator (○
transmitter is ready for pairing.
Now, turn receiver on. It will be paired and channel unified. Indication of successful or failed
pairing is shown above.
Turn receiver off and then re‐turn it on if failed pairing happens.
Pairing quantity shown on transmitter will gradually increase until pairing is completed.
To release the transmitter from group pairing, simply short press the call button (○
have it at standby screen or press the power button (○
Send pairing data to another transmitter
st
Keep 1
cannot release itself from pairing mode at this step.
Now, press both call (○
pairing data from 1
on both transmitters (if the communication mode is "Teaching", the master/slave switch (
both transmitters needs to be tuned at "m").
nd
Turn 2
To release transmitters from transmission/acquirement of pairing data, simply short press the
call button (○
directly.
transmitter on after it has paired all group members (receivers). Note this transmitter
) and power (○
6
st
transmitter. Note same communication mode and channel need to be set
transmitter off and then re‐turn it on if failed acquirement of pairing data occurs.
) again to have it at standby screen or press the power button (○
6
) starts to flash quickly which means the
3
) to turn it off directly.
9
(Successful acquirement of pairing data)
nd
) buttons to turn 2
transmitter on in order to obtain
9
14
6
(Failed acquirement of pairing data)
) to turn it off
9
) again to
○
) on
10
Hide quick links:
Advertisement
