Menu List Showing The Level Of The Admin Number (Password); Energysaving (Settings Related To Energy Saving) - Panasonic CZ-256ESMC3 Technical Data Manual

Menu list showing the level of the admin number (password)


1. Select the top menu
y Touch the "EnergySaving" "Oper./
Status" "Settings" tab.
2. Select the sub menu

EnergySaving (Settings related to energy saving)

Sub menu
★
★
★
★
★
★
★
★
★
★
★
* When using gas heat pump air conditioners
* The numbers in parentheses indicate page number of this Technical Data.
EnergySaving
Screen menu
Set temp. auto return
Unattended auto shutoff
Set temperature range limit
Energy saving timer/
Efficient operation setting *
Out unit silent setting
I/D unit demand settings
O/D unit demand settings
Demand/peak shaving settings
*
O/D unit cyclic
I/D unit cyclic
Register demand point
Bar chart
Line graph
Overview
Even if the temperature initially set is changed, the
temperature automatically returns to the set one
after a certain amount of time.
If the indoor unit automatically stops at the set time
but then is started again, this setting automatically
stops the unit again repeatedly at set intervals.
Restrict the temperatures that can be set by setting
upper and lower limits on temperatures.
You can specify time slots when you want operation
capacity reduced.
Set a time for the outdoor unit to operate at a lower
noise level at night compared to the day.
You can automatically control indoor units to cut the
maximum demand for electricity or maximum gas
consumption.
You can automatically control outdoor units to cut the
maximum demand for electricity or maximum gas
consumption.
Limit the electricity or gas consumed by outdoor
units during the set time slot.
At 10 minute intervals, the thermostats of outdoor
units in control groups are turned off and restored
repeatedly in order.
At specified intervals (3, 4, or 5 minutes), the
thermostats of indoor units in control groups are
turned off and restored repeatedly in order.
Register contact points (A contact, B contact, C con-
tact) between the demand controller and the main
unit.
Quantities of energy usage (electricity, gas), etc. are
shown in bar charts.
Temperature changes, etc. are shown in line graphs.
ー 176 ー
Other miscellaneous settings
Operating
Instructions
page
77 (84)
80 (86)
83 (87)
85 (88)
87 (89)
89 (90)
92 (92)
94 (93)
101 (96)
97 (94)
104 (98)
109 (100)
113 (102)