Shimano Ultegra R8050 Series Dealer's Manual page 82

INSTALLATION OF HYDRAULIC DISC BRAKE SYSTEM
Installation of the brake hose (easy hose joint system)
Prepare the connector insert for insertion into the brake hose as follows.
Attach the connector insert to the press block and then set the press block in the tool.
Make sure that the tip of the connector insert is correctly positioned inside the opening of
the brake hose.
[1]
(A)
10
(B)
Grip the lever on the tool to insert the connector insert into the brake hose, as shown in the
illustrations.
Check that the connector insert has been inserted correctly, and then remove the brake hose
from the tool.
[1]
11
To be continued on next page
[2]
[2]
82
(A)
Press block
(B)
Connector insert