Shimano Ultegra R8050 Series Dealer's Manual page 35

INSTALLATION
Installation of the dual control lever and brake cable
ST-R8050
1
(A)
2
To be continued on next page
Turn over the bracket cover from the
back side.
Gently turn over the ends of the bracket
cover with both hands and slowly push
them down.
(A)
Use a 5 mm hexagon wrench to tighten
the clamp bolt at the top of the bracket.
35
(A)
Clamp bolt
NOTE
Forcibly pulling it may cause damage to the
bracket cover because of its material
properties.
(A)
Clamp bolt
Tightening torque
6 - 8 N·m
NOTE
•
With a carbon handle, even the
recommended tightening torque may be
too tight and cause damage to the handle,
or too loose and not sufficiently attached.
For the appropriate torque value, consult
with the manufacturer of the completed
bicycle or the manufacturer of the handle.
•
The clamp band, clamp bolt, and clamp nut
are not compatible with other products. Do
not use with components that are used in
other products.