Shimano Ultegra R8050 Series Dealer's Manual page 56

INSTALLATION
Installation of junction A (EW-RS910)
Remove the release back sheet from the handle holders, and then install them to the
handlebar.
[1]
4
(A)
5
(B)
To be continued on next page
[2]
(A)
(A)
Secure the electric wires to the
handlebar using tape or a similar
material.
56
(A)
Handle holder
TECH TIPS
•
There are two handle holders which differ
in shape.
Attach [1] fi rst and then [2].
[1] [2]
•
After attaching them to the handlebar,
hold down the handle holders with your
fi nger for 1 minute.
•
If the double-sided tapes have diminished
in adhesive strength after replacing the
handle holders etc., cut some store-bought
double-sided tape and replace them.
15 mm
(A)
Electric wire
(B)
Tape
TECH TIPS
When securing the electric wires, make length
adjustments by tucking any excess length into
the handlebar etc.
10 mm