Shimano Ultegra R8050 Series Dealer's Manual page 80

INSTALLATION OF HYDRAULIC DISC BRAKE SYSTEM
Installation of the brake hose (easy hose joint system)
Orient the brake hose connection port of the dual control lever securely upward by
changing the angle of the handlebars or another means.
5
Prepare the Shimano original tool TL-BH62 for cutting the brake hose as follows.
Disassemble the Shimano original tool TL-BH62 as shown in the illustrations.
[1]
6
[3]
To be continued on next page
[2]
[4]
(A) (B)
(C)
80
NOTE
To install the handlebar, adjust the angle of
the bracket by tilting the bracket from the
handlebar so that you can turn the spanner.
At that time, be careful not to damage the
handlebar and other parts.
Handlebar
(A)
Body of tool
(B)
Hose cutter
(C)
Press block
NOTE
•
Do not move the lever indicated in the
illustration before disassembling the
Shimano original tool TL-BH62.
•
Make sure to also read the instruction
manual for the Shimano original tool
TL-BH62.