Table of Contents
Advertisement
•
Make sure the TX frequency and PL Code in
the radio channel that has been chosen for
repeater, is the same as the RX frequency in
the repeater. Same for the RX frequency in
your RDX radio: make sure it matches the TX
frequency and PL code in the repeater's
channel.
•
The repeater has 16 channels available, each
one with two TX/RX frequency pairs. You can
either use the repeater default programmed
frequencies and customize the RDX channels
to match the repeater's or you can customize
the repeater frequencies to different
frequencies pairs to match frequency in the
RDX radios.
Note:
Take into account that when matching
channel frequencies between the repeater
and the radios, you must also need to make
sure all other channel parameters (i.e.
codes, bandwidth and reverse burst) are at
the same correspondent values in order for
the radios-repeater communications to take
place properly.
User Guide
45
Advertisement
Table of Contents
