Table of Contents
Advertisement
To connect AC/DC power supply:
Plug the AC/DC power supply into an AC
1.
power source of 110/220 Vac or a 12 VDC
power and route it to the Repeater Jack
labeled "AC/DC IN".
Note:
The cable from the power supply should be
routed in a straight line and should not
tangle, go around or wrap around the
repeater device, the antenna or the RF
Cable. See "Figure 7a. Repeater Cable
Layout Using Dipole Antenna P/N
HKAE4000" on page 18 (Notice in this
picture that the cable must be laid down
straight for at least 2 feet).
Vehicle Charger
The repeater offers the convenience of a
Vehicle Charger accessory (P/N HKPN4003,
sold separately).
Figure 15a. Vehicle Charger
Installation Guide
27
Advertisement
Table of Contents
