Table of Contents
Advertisement
The repeater comes from the factory with the wall
mount attached to the repeater. Detach it by
pushing out the bottom tab as shown in Figure 14b
below:
Wall mount
bottom tab
Figure 14b. Detaching the Wall Mount from the
Repeater
To install the wall mount:
1.
The wall mount holster is designed to be
capable of mounting to a wall or any other
similar flat surface via screws, straps or
single bolt. (If you choose to use screws,
make sure you secure them tightly on each
one of the wall mount corners).
Important
2.
Pull tab on the
bottom of the
repeater and slide
down the
holster
3.
Installation Guide
Remember not to install the repeater on
or near conductive or shielding
surfaces.
Once the wall mount is firmly secured to a
surface, slide the repeater device from top to
bottom of the holster ("Figure 14c. Installing
the Wall Mount Holster" on page 26) until the
repeater clicks in place into the wall mount
rails.
Proceed to connect antenna and power
supply cables.
25
Advertisement
Table of Contents
