TurboChef Double Batch Service Manual page 20

6 OVEN MAINTENANCE
Step 6
Step 7
Step 8
Step 9
Step 6: Apply Oven Guard (Top and Bottom Oven)
- Spray Oven Guard onto a clean towel.
- Wipe the interior walls and the inside of the oven doors.
CAUTION: DO NOT spray Oven Guard into the holes on the back oven walls or directly
onto the cook chamber lamps. Doing so can damage critical oven components, resulting in a
non-warranty service call.
Step 7: Reinstall the Grease Filters and Wire Racks (Top and Bottom Oven)
- There are notches on the rear right and left sides of the wire rack which fit over the pins
on the sides of the cook chamber. The wire rack must be installed correctly to ensure proper
oven operation.
Step 8: Clean the Air Filter
CAUTION: TurboChef does not recognize blocked air vents as a warrantable claim. The
filter must be cleaned regularly or replaced if damaged. During oven operation, the filter
must remain in place at all times.
- Remove the air filter from the back of the oven.
- Rinse the air filter with hot water. DO NOT scrub the filter.
- Allow the air filter to dry completely.
- Reinstall the air filter.
CAUTION: DO NOT operate the oven without the filter in place.
Step 9: Clean the Oven Exterior
- Wipe the oven exterior with a clean, damp towel.
CAUTION: DO NOT spray chemicals into any openings, such as the louvers on the side
or rear panels. Doing so can damage critical oven components, resulting in a non-warranty
service call.
- Wipe the oven exterior with a clean, dry towel.