Connections; 1-3. Use Of A Display Stand - Sony Trinitron Multiscan CPD-1302 Service Manual

;:PD-1302
1·2. CONNECTIONS
Use an appropriate optional color monitor cable with 9-pln D·sub con·
nectors shown in the table.
Be sure to turn the power of the unit off before making any connections.
Equipment that can
be connected
IBM PC, ·AT, XT
with CGA
IBM PC, AT, XT
with EGA, CGA, MDA
IBM 3270
IBM PC, AT, XT
with PGA
Monitor cable Position of RGB
(optional) input selectors
to be used of the CPD·1302
SMF·512 D1·DlGITAL
SMF·512 D2·DIGITAL
SMF·514 NORM·DIGITAL
SMF·513 ANALOG
Rear of the CPD·I302
',r,:-_ _ _ _ _
~II
o
o
Set to appropriate :
positions. -;''''' IL
"': ""''''+='''~ ' '' '''=:'-
_ _ _ _ ...JI
Microcomputer
to the AC power
Input connector
.. to a
AC power wall
cord (supplied) outlet
1
Align the plug with the receptacle.
2
Plug in and tighten the
screws.
~ ~
, To disconnect the plug, loosen the screws,
Note
The monitor cable should arrange the RGB output signals of the con·
nected equipment so that they match the signal assignment of the RGB
IN connector of this unit (See page 10). If you are not sure whether you
can use your computer or character generator with CPD·1302 or which
monitor cable to use, consult your authorized Sony dealer.
1-3. USE OF A DISPLAY STAND
With the optional Sony SU·535 display stand, this unit can be adjusted
to be viewed at your desired angle within goo horizontally and 15° ver.
tically.
15°
For details, read the instructions of the display stand,
- 6 -