Boss Dr.Sample SP-202 Owner's Manual page 47

It initialization is not performed automatical l y, and you experience problems such
as
"noise mixed with the sample sound"
or
"irregularities occurring in the samples
of other pads when recording or erasure is performed,"
refer to the procedure on
page 25 of the owner's manual, and completely erase either the i n ternal memory (if
the problem occurred in bank A or B) or the memory card (if the problem occurred
in bank C or D).
If the above cautions are not observed, thereby causing the data of the i n ternal
flash memory to be damaged, the display may indicate "Err" for several seconds
the next time the unit is turned on, and internal data will be automatically initi a lized.
(All internal data is lost. )
When initialization i s completed, the SP-202 will then enter the same state as fol-
lowing a normal power-on.
* If the BPM display becomes darker than normal, the battery
capacity has nearly run down. Please replace the battery as
soon as possible.
Never turn off the power and remove a memory card in the follow-
ing situations.
• While a sample is being deleted (the DEL button is lit)
• While Truncate is being performed (the DEL button is lit)
• While saving data to a memory card (the REC button is lit)
• While loading data from a memory card (the REC button is lit)
• While the decimal points in the BPM display are blinking
The SP-202 stores sample data and various data necessary for operation in its
internal flash memory or a memory card.
If the power is turned off, a memory card is removed, or the battery runs down while
data in fl a sh memory or a memory card is being written or erased, the data will not
be written correctly. In such cases, not only will your important data be lost, but
subsequent operation of the uni t may also be affected.
When using the SP-202, please be sure to observe the following
cautions.
Important
~13055