Deleting Unwanted Portions (Truncate); Reverse Playback (Play Backward); Reverse Playback - Boss Dr.Sample SP-202 Owner's Manual

28
__ II I
I __ __,
'\ \ I I,
:REVERSe:
, ...
't
I''
2.
Press the NORMAL/REVERSE button to make
REVERSE light.
1.
Press the pad which contains the sample that you
wish to playback in reverse. (Specify the current
pad)
The pad will light, and the sample will sound.
Reverse playback
Normal
Reverse playback makes the sample play backward, produc-
ing an effect similar to when a tape is played backward.
I
Reverse playback
(play backward)
5.
Press the DEL button.
The DEL button will light, and after several seconds will
go dark, indicating that the Truncate operation has been
completed.
After the waveform has been Truncated, the MARK but-
ton will go dark.
• Never tum off the power while the DEL button is lit.
4.
Press the MARK button.
The MARK button
will
blink.
3. Press the DEL button.
The DEL button will blink.
E]
2.
Make sure that the Start and End Points have
been set (the MARK button is lit).
1, Press the pad which contains the sample that you
wish to Truncate. (Specify the current pad)
The pad will light, and the sample will sound.
----
portion which plays back
J
Truncate
End point Start point
unwanted unwanted
End of
sample
I
Beginning of
sample
I
When you specify the Start/End Points (page
27-28),
unused
portions of waveform data will occur. By deleting
(Truncating) these portions, you can make more efficient use
of memory.
I
Deleting unwanted portions
(Truncate)
• If
the setting was not made as desired, press the lit
MARK button while the sound is still playing to make it
go dark, and re-do the procedure from step
l.
3. Press the pad (or in the case of Gate playback,
release the pad) to stop playback.
The MARK button will light, and the setting will be com-
pleted.
START/
ENDPOINT
EJ
2.
When you reach the desired Start Point, press the
MARK button.
The MARK button
will
blink.
1.
Hold down the MARK button, and press the pad
which contains the sample that you wish to edit.
(Specify the current pad)
The pad will light, and the sample will sound.
• In the case of Gate playback, continue holding the pad.
• Adiosting only the Start Point (End
Point is the end of the sample)
• If
the setting was not made as desired, press the lit
MARK button while the sound is still playing to make it
go dark, and re-do the procedure from step l.