Boss Dr.Sample SP-202 Owner's Manual page 40

40
11.Repeat steps 5-10 to sample the desired phrases.
* You may skip step 6, because when you sample, the SP-
202 automatically selects a pad to which no sample has
been assigned.
e. Press the DEL button.
The DEL button will light. When it goes dark, the delete
operation has been completed.
*
Never turn the power off while the DEL button is lit.
b.
Press the pad whose sample you wish to delete.
(Pad will blink)
a.
Press the DEL button. (The button will blink)
Delete the sound that you sampled and try the procedure
again from step 5. The delete procedure is as follows.
e
If you don't like the sound you sampled
*
If there is an interval of silence at the beginning of the
sound or an unwanted portion at the end of the sound
when you playback, you can use the editing operation
described in the section "Playing only the desired por-
tion of a sound" (page 27) so that only the desired por-
tion is heard.
10. When you wish to stop sampling, press the SAM·
PLING START/STOP button. Sampling will end,
and the blinking pad will go dark.
Press the pad and listen to the sound that you just sam-
pled.
If
the sound is satisfactory, press the pad to stop
playback (the pad will go dark), and continue with step
11.
9. Start playback of the CD, and in synchronization
with the beginning of the desired sound from the
CD, press the SAMPLING START/STOP button.
The REC button will light, and sampling will begin.
8.
Stop the CD player, and put
it
once again in play-
back standby mode.
7. Adjust the sampling level.
Start playback on the CD, and rotate the REC LEVEL
knob to adjust the level so that PEAK lights occasionally.
6,
Press the BANK INT A/B button (or if you are
using a memory card, the CARD CID button) and
a pad to specify the pad and bank to which the
sampled sound will be assigned.
The selected pad will blink.
* Even if you press a pad to which a sample is already
assigned, it will not blink.
*
If
you decide to cancel the sampling operation, press the
CANCEL button. The REC button will go dark.
5,
Press the SAMPLING ST ART/STOP button.
The REC button will blink, and the SP-202 will be in
standby mode. ,At this time, a pad to which no sample
has been assigned will be selected automatically and will
blink.
4.
Make sure that the SP-202's SOURCE
MIX
switch
is OFF and that the SOURCE SELECT switch is
LINE, and then turn the SP-202's power switch
ON.
3,
Set the SOURCE SELECT switch to LINE.
2,
Tum on the power of the CD player, and put the
CD in playback standby mode.
1, Connect your CD player. (page
8, 9)
I
Sampling various phrases
This section will explain how to create break-beats, and the
basic procedure of how to connect these to create a song.
Using the SP-202's Time Stretch function which allows you
to modify the tempo without affecting the pitch, it's also
easy to connect phrases whose tempo is different.
* Unauthorized sampling from a CD, record, tape, video
production, or broadcast etc. whose copyright
is
owned
by a third party is forbidden by law, with the exception
of special cases such as private use.
You can sample a variety of basic phrases of a few measures
(mainly rhythms) from various songs, and use them as
break-beats.
Section
7.
Creating break-beats