Connections For Dvi And Rs-232 With Dvi To Rs-232 Loopthrough - Barco NSL-4601 User Manual

Installation
4.4.3 Connections for DVI and RS-232 with DVI to RS-232
loopthrough
In this case, all displays (SET1, 2, 3 and 4) must be configured as master. The
DVI source is connected to each display. The RS-232 needs to be connected to
the first display (SET1), the other displays (SET 2, 3 and 4) are connected
together for RS-232 data tranmission by using the DVI to RS-232 cable. See
also the RS-232 DIP switch setting paragraph for the master/slave configuration
of the display.
1
1
1
2
3
Figure 5: DVI and RS-232 connection with DVI to RS-232 (e.g. Digital Signage
with 4 units)
18 ______________________________________________________ Barco - NSL-4601 - User manual
SET 1: Master
2
SET 4: Master
Digital Video Input signal (DVI source needs to be connected with all sets)
RS-232 In via RS cable (RS-232 cable needs to be connected with set 1)
RS-232 data transmission is done via DVI to RS-232 cable
(DVI-out needs to be connected to RS-232 In of the next set)
1
3
1
SET 2: Master
SET 3: Master