Table of Contents
Advertisement
3.3.2
Power cabling
3.3.2.1 Connections with a Mono Phase Power Box
Necessary parts
•
Mono Phase Power Box for outdoor use.
•
Power Linking Cable.
•
Sealing rings.
•
Cable ties.
•
Dummy Power Plugs.
Power Connections
1. Attach the Standard DLite Mono Phase Power Box to the rear side of the SLite Display. Use four bolts and nuts for fixation.
(image 3-15)
2. Check if the correct sealing rings are present in the connector sockets of the connection module located at the back side of each
tile. Replace damaged sealing rings immediately. Use the correct sealing ring for the corresponding socket. Black colored ring
for power, red for data. (image 3-16)
3. Start creating power branches by connecting the output cables of the power box with the power input socket of the lowest tile in
a column of maximum three.
4. Complete each power branch by connecting a maximum of three tiles with power linking cables to each other in a daisy chain
manner.
Warning: Maximum 3 (three) tiles per branch are allowed. Connecting more then three tiles with one output cable will overload
the circuit.
5. Terminate the power output socket of the last tile in each column with a Dummy Power Plug. (image 3-17)
6. Make sure that all plug holder clamps are locked firmly.
7. Attach long cables with cable ties to the frame.
8. Connect the power box with the local power net. In case the local power net is not provided with an earthwire an additional earth
connection must be installed and connected with the protected earth inside the power box.
Image 3-15
DLite Mono Phase Power Box.
R5976575 FIXED SLITE DISPLAY 17102003
Image 3-16
Sealing rings.
A
Red sealing ring for 'DATA IN' and 'DATA
OUT' sockets (B361595).
B
Black sealing ring for POWER IN' and
'POWER OUT' sockets (B361243).
3. Physical installation
25
Advertisement
Table of Contents
