Emotiva XPA HC-1 User Manual page 14

4. Unbalanced (RCA) Input
Audiophile quality gold plated machined RCA input connector (accepts a line level unbalanced
input).
5. Balanced (XLR) Input
Standard XLR connector (accepts a line level balanced input).
6. Circuit Breaker
The XPA HC-1 is protected by a heavy duty user-resettable Circuit Breaker. In the unlikely event
that the circuit breaker trips, the button on the Circuit Breaker will pop up, and extend above the
rear panel. When the Circuit Breaker button is out, the XPA HC-1 will not operate, and none the
Status LEDs and Standby Button will not be lit. To reset the Circuit Breaker, press the button firmly
in.
In the unlikely event that the circuit breaker trips, the button will pop out and extend
noticeably from the rear panel. If this happens, try resetting the Circuit Breaker by pressing
the button firmly in. If the Circuit Breaker trips a second time, please contact Emotiva, or your
nearest authorized Emotiva service representative.
7. IEC Power Cord Receptacle
The XPA HC-1 can be powered by any receptacle that provides between 100 VAC and 250 VAC
at 50/60 Hz. This receptable accepts a standard removable IEC AC power cable (a high-quality
commercial power cable is included).
Note: The XPA HC-1 will provide excellent performance and exceptional sound quality with any
line voltage between 100 VAC and 250 VAC; however, for the absolute ultimate in performance,
a 230 VAC line is recommended.
8. AC Power Switch
Switches the main AC power to the XPA HC-1 On and Off. When this switch is Off, no controls
operate (the XPA HC-1 cannot be turned On from the front panel or by a trigger signal).
9. Speaker Terminals
Heavy duty audiophile quality five way binding posts with gold-plated contacts and clear covers
accept speaker wires with banana plugs, spade lugs, or bare wire terminations.
XPA HC-1
Page 10