Installation Of Outdoor Unit; Check Before Installation; Selection Of Installation Site; Carrying And Installing Outdoor Unit - Gree FGR25Pd/DNa-X Service Manual

FGR25Pd/DNa-X(I)
FGR30Pd/DNa-X(I)
FGR40Pd/D(2)Na-X(I)

4 Installation of outdoor unit

4.1 Check before installation

a. Before installation, please check the power cord if it complies with the power supply requirement
on the nameplate. Make sure the power supply is safe.
b. This air conditioner must be properly grounded through the receptacle to avoid electric shock.
The ground wire shouldn't be connected with gas pipe, water pipe, lightning arrester or telephone line.
c. Maintain good air circulation to avoid lacking oxygen.
d. Read this manual carefully before installation.

4.2 Selection of installation site

a. Select a location which is strong enough to hold unit's weight so that unit can stand still and erect.
b. Make sure the unit is not exposed to sun and rain. And the location can resist dust, typhoon and
earthquake.
c. Please keep the unit away from inflammable, explosive and corrosive gas or waste gas.
d. Make sure the location has space for heat exchange and maintenance so that unit can operate
reliably with good ventilation.
e. ODU and IDU should stay as close as possible to shorten the length of refrigerant pipe and
reduce bend angles.
f. Select a location which is out of children's reach. Keep the unit away from children.

4.3 Carrying and installing outdoor unit

When carrying the outdoor unit, hang the unit in four directions with two sufficient ropes. In order to
avoid excursion from the center, the angel of ropes must be smaller than 40º during hanging and
moving.
4.4 Installation notices
In order to ensure proper operation, the selection of installation site must conform to the following
principle:
●The discharged air of outdoor unit will not flow back and there is sufficient space around the unit
for maintenance;
●The installation site must be well ventilated to ensure sufficient air intake and discharge. Make
sure there is no obstacle at the air inlet and air outlet. If there is any obstacle, please remove it;
●The installation site shall be able to withstand the weight of outdoor unit and capable for
soundproof and vibration. The air outlet and noise of unit will not affect neighbors;
●The hanging of outdoor unit must use appointed hanging hole. Pay attention to protect the unit
during hanging and installation. Prohibit hitting the sheet metal to avoid rust in the future.
●Avoid direct sunlight;
Duct type split Air conditioner Inverter Series
220V~50/60HZ
220V~50/60HZ
3N~ 380V 50/60HZ
10 1×1.5
10 1×1.5
10 1×1.5
71
2×1.5
2×1.5
4×1.5