System Start-Up And Viewfinder Display Control - Sony CA-901K Operation Manual

System Start-up and Viewfinder
Display Control
The following explanation covers only operations
which differ from stand-alone camera operations.
Powering the system (be sure to observe
the following procedure)
1
Set the CA-550/550P POWER switch to CCU/
EXT and CAMERA POWER switch to ON.
2
Set the CCU MAIN POWER switch and
CAMERA POWER switch to ON.
The green power indicator on the rear panel of this
unit will light.
Marker display
Set the CURSOR/MARKER switch on the rear panel
of this unit to MARKER ON.
MARKER ON, CURSOR ON: To display the box
cursor, the safety zone (90 % of the shooting area)
marker, and the center marker in the viewfinder
screen.
MARKER ON, CURSOR OFF: To display the
safety zone marker and the center marker in the
viewfinder screen.
Use an internal switch of this unit to change the size of
the safety zone to 80%.
For more information, refer to the maintenance manual.
Note
Double markers will be displayed if you set the
CURSOR/MARKER switch of this unit to ON while
the camera's marker display setting is on. Be sure to
set the camera's marker display to off.
Box cursor control
1
Set the CURSOR/MARKER switch on the rear
panel of this unit to CURSOR ON.
The box cursor, the safety zone marker, and the
center marker will be displayed in the viewfinder
screen.
Box cursor
2
Use the H-POSI, V-POSI, WIDTH and HEIGHT
knobs to adjust the size and position of the cursor.
Safety zone marker
Center marker
Viewfinder screen
19(E)