When D/A Converter Module Is Connected To Head Module - Mitsubishi MELSEC L Series User Manual

10.3
When D/A Converter Module is Connected to Head
Module
This section describes system configuration of the D/A converter module and a program example of operation
condition.
(1) System configuration
Power supply module (Q62P)
CPU module (Q10UDHCPU)
Master/local module (QJ71GF11-T2)
Input module (QX10)
Output module (QY10)
Masster station (Station No.0)
(2) Programming conditions
This section describes the example of outputting analog values by setting CH1 and CH2 of the D/A converter
module to D/A conversion enabled.
When a write error of digital value occurs, the error code is displayed in BCD.
Scaling setting is configured only for CH1 and warning output function only for CH2.
(3) Description of initial setting
Setting items
D/A conversion enable/disable setting
Warning output function
Warning output upper limit value
Warning output lower limit value
Scaling enable/disable setting
Scaling upper limit value
Scaling lower limit value
X/Y00 X/Y20 X/Y30
to to to
X/Y1F X/Y2F X/Y3F
Ethernet cable (1000BASE-T)
Network No.1
CH1
Enabled
Disabled
−
−
Enabled
32000
0
Power supply module (L61P)
Head module (LJ72GF15-T2)
D/A converter module (L60DA4)
Input module (LX40C6)
Output module (LY10R2)
END cover (L6EC)
X/Y1000
to
X/Y100F
Intelligent device station (Station No.1)
CH2
Enabled Disabled
Enabled Disabled
−
10000
−
3000
Disabled Disabled
− −
− −
CHAPTER 10 PROGRAMMING
X/Y1010 X/Y1020
to to
X/Y101F X/Y102F
CH3 CH4
Disabled
Disabled
−
−
Disabled
−
−
10
83