Chapter 7 Various Settings; Addition Of Modules - Mitsubishi MELSEC L Series User Manual

CHAPTER 7
This chapter describes the setting procedures of the D/A converter module.
After writing the contents of new module, switch settings, parameter settings and auto refresh settings into the CPU module,
reset the CPU module, switch STOP → RUN → STOP → RUN, or switch OFF → ON the power supply, to validate the
setting contents.
7.1

Addition of Modules

Add the model name of D/A converter modules to use on the Project.
(1) Addition procedure
Open the "New Module" dialog box.
Project window
Module Type
Mount Position
Title Setting
38
VARIOUS SETTINGS
[Intelligent Function Module]
Item
Module Type Set "analog module".
Module Name Select the name of the module to be connected.
Mounted Slot No. Set the slot No. where the target module is connected.
Specify start X/Y The start I/O number (hexadecimal) of the target module is set, according to
address the mounted slot No. Setting any start I/O number is also possible.
Title Set any title.
Right-click [New Module...]
Description