Table of Contents
Advertisement
24-Port Channelized T1/E1/J1 CEoP SPA Interface Specifications
LED Label
A/C
24-Port Channelized T1/E1/J1 CEoP SPA Interface Specifications
The physical layer interface for the 24-Port Channelized T1/E1/J1 CEoP SPA is a customer-installed
high-density connector. This connector has thumbscrews that should be screwed into the SPA when the cable
is installed.
24-Port Channelized T1/E1/J1 CEoP SPA Cables and Connectors
The 24-Port Channelized T1/E1/J1 CEoP SPA requires a Cisco cable (part number CABLE-24T1E1J1), which
is shown in the figure below.
Figure 52: 24-Port Channelized T1/E1/J1 CEoP SPA High-Density Cable
Cable Installation
One end of the cable has a 100-pin connector that plugs into the front of the 24-Port Channelized T1/E1/J1
CEoP SPA. Use the thumbscrews on either side of the connector to secure the cable to the SPA.
The other end of the cable has two 50-pin Telco connectors that can be attached to the rear of a 24-port RJ-45
patch panel. Both connectors are identical: one is for Transmit (TX) and the other is for Receive (RX). The
following figure shows how the cable is connected between the 24-Port Channelized T1/E1/J1 CEoP SPA
and the patch panel.
Cisco ASR 9000 Series Aggregation Services Router SIP and SPA Hardware Installation Guide
62
Color
State
Meaning
Amber
On
SPA power is on and good, and SPA is being configured.
Green
On
SPA is ready and operational.
Off
Off
Port is not enabled by software.
Green
On
Port is enabled by software.
Amber
On
Port is enabled by software, and there is at least one alarm.
Overview: Cisco ASR 9000 Series Router Shared Port Adapters
Advertisement
Table of Contents
