Table of Contents
Advertisement
8-Port OC-3/STM-1 POS SPA Interface Specifications
Figure 31: 8-Port OC-3/STM-1 POS SPA Faceplate
1
C/A (Carrier/Alarm) LED
2
A/L (Active/Loopback) LED
The following table describes the 8-Port OC-3/STM-1 POS SPA LEDs.
Table 28: 8-Port OC-3/STM-1 POS SPA LEDs
LED Label
C/A
A/L
STATUS
8-Port OC-3/STM-1 POS SPA Interface Specifications
The framer processes incoming and outgoing SONET or SDH frames. The framer operates at OC-3 line rates
(155.52 Mbps). Packet data is transported with a user-configured encapsulation (such as Point-to-Point Protocol
[PPP]) and is mapped into the Layer 2 frame.
The 8-Port OC-3/STM-1 POS SPA interface complies with the following RFCs:
• RFC 1662, PPP in HDLC-like Framing
• RFC 2427, Multiprotocol Interconnect over Frame Relay
• RFC 2615, PPP over SONET/SDH
Cisco ASR 9000 Series Aggregation Services Router SIP and SPA Hardware Installation Guide
42
3
STATUS LED
Color
State
Meaning
Off
Off
SONET controller is shut down.
Green
On
Port is enabled by software, and there is a valid SONET signal without any alarms.
Amber
On
Port is enabled by software, and there is at least one alarm.
Off
Off
Interface is shut down.
Green
On
Port is enabled by software, and loopback is off.
Amber
On
Port is enabled by software, and loopback is on.
Off
Off
SPA power is off.
Green
On
SPA is ready and operational.
Amber
On
SPA power is on and good, and the SPA is being configured.
Overview: Cisco ASR 9000 Series Router Shared Port Adapters
Advertisement
Table of Contents
