Connecting Auxiliary Audio Equipment - Sony MEX-5DI Operating Instructions (XT-XM1) Operating Instructions Manual

Adjusting the cut-off frequency for the
subwoofer(s)
To match the characteristics of the connected
subwoofer(s), you can cut out the unwanted high
and middle frequency signals entering the
subwoofer(s). By setting the cut-off frequency
(see the diagram below), the subwoofer(s) will
output only low frequency signals for a clearer
sound.
Cut-off frequency
Frequency (Hz)
1
During playback or radio reception,
press (MENU).
2
Press < or , repeatedly to select
"SoundTuning."
3
Press (ENTER).
4
Press M or m repeatedly to select
"LPF."
5
Press (ENTER).
6
Press M or m repeatedly to select the
cut-off frequency.
Each time you press M or m, the frequency
changes as follows:
OFF (default setting) y 125 Hz y 78 Hz
7
Press (MENU).
After the frequency setting is complete, the
display returns to the normal display.
off
Connecting auxiliary audio
equipment
The unit's AUX IN (external audio input)
terminal on this unit is also used as the BUS
AUDIO IN (audio input) terminal.
You can listen to the sound from your car
speakers by connecting optional Sony portable
devices.
Note
If you connect an optional Sony CD/MD unit, you
cannot connect any portable devices and cannot
select "AUX."
Selecting auxiliary equipment
Press (SOURCE) repeatedly to select
"AUX."
Adjusting the volume level
You can adjust the volume for each connected
audio equipment.
1
Press (MENU).
2
Press < or , repeatedly to select
"SoundTuning."
3
Press (ENTER).
4
Press M or m repeatedly to select
"AUX Level."
5
Press (ENTER).
6
Press < or , repeatedly to adjust
the volume level.
The volume level is adjustable in 1 dB steps
from –6 dB to +6 dB.
7
Press (ENTER).
The display returns to the top menu display.
8
Press (MENU).
The display returns to the normal display.
continue to next page t
45