Sony MEX-5DI Installation/Connections

MG-MS/FM/MW/LW
Compact Disc
Player
Installation/Connections
MEX-5DI
Sony Corporation © 2002
1
121 mm
19 mm
9.5 mm
59 mm
Dimensions include unit size, front panel and disc tray open, etc.
2 1
4
7
Equipment used in illustrations (not supplied)
Front speaker
Rear speaker
Active subwoofer
3-242-050-21 (1)
Printed in Japan
142.5 mm
170 mm
2 3
5 6
× 4
8 9
Power amplifier
CD/MD changer
3 A
B
Cautions
• This unit is designed for negative earth 12 V
DC operation only.
• Do not get the wires under a screw, or caught
in moving parts (e.g. seat railing).
• Before making connections, turn the car
ignition off to avoid short circuits.
• Connect the yellow and red power input leads
only after all other leads have been connected.
• Run all earth wires to a common earth
point.
• Be sure to insulate any loose unconnected
wires with electrical tape for safety.
Notes on the power supply cord (yellow)
• When connecting this unit in combination with
other stereo components, the connected car
circuit's rating must be higher than the sum of
each component's fuse.
• When no car circuits are rated high enough,
connect the unit directly to the battery.
Before installation (1)
× 2
Do not install the unit where its operation
interferes with driving.
Example:
— Opening and closing of the front panel or
disc tray interfere with operation of the gear
shift.
— With the front panel open, operation of
hazard lamps, switches etc., is impaired.
AUDIO OUT
SUB OUT (MONO)
FRONT
AUDIO OUT
REAR
BUS AUDIO IN
BUS CONTROL IN
BUS AUDIO IN
Source selector*
*
XA-C30
BUS CONTROL IN
Parts Iist (2)
The numbers in the list are keyed to those in the
instructions.
For the use of release key 9, see the supplied
operating instructions.
Caution
Handle the bracket 1 carefully to avoid injuring
your fingers.
Connection example (3)
Note (3-A)
Be sure to connect the earth cord before connecting
the amplifier.
Tip (3-B- )
For connecting two or more CD/MD changers, the
source selector XA-C30 (optional) is necessary.
* not supplied