Setting A Panorama Image; Panorama - Sony MEX-5DI Operating Instructions (XT-XM1) Operating Instructions Manual

Setting a panorama image

— Panorama (Panorama/Wall paper mode)
Scrolls a static image in a "Memory Stick" or
displays it in tile.
The image data you set will be stored in this unit.
To display the pre-stored images in this unit, see
"Selecting the display mode and display pattern"
on page 13.
1
Insert a "Memory Stick" (page 10).
2
Press (GRAPHIC).
3
Press < or , repeatedly to select

"Panorama."

Each time you press < or ,, the item
changes as follows:
Wall Paper y Panorama y Jacket
Pic y ClipMotion y Slide Show y
Picture Del y Char Setup
4
Press (ENTER).
5
Press (ENTER) again.
6
Press M or m repeatedly to select a
location or type of image that you want
to set.
Picture Select: If an image you want to set
is in the first layer of a "Memory Stick,"
select this.
Cyber-shot: If you want to set a picture
taken by an optional Sony digital still camera
Cyber-shot, select this.
(Folder name): When a folder is in a
"Memory Stick," the folder name is
displayed.
7
Press (ENTER).
Select the folder name in step 6. If there are
images in folders of a lower layer, repeat step
6 and 7 to select the folder which contains
your desired image.
An image can be set in up to the 5th layer
folder in a "Memory Stick."
8
Press < or , repeatedly to select the
image you want to set.
34
9
Press (ENTER).
Depending on the aspect ratio of the selected
image, the display type will be set
automatically.
1:1 to 1:4 tile
–
more than 1:4 scroll horizontally
–
below 1:1 scroll vertically
–
10
Press (ENTER) again.
11
Press (GRAPHIC).
The display returns to the normal display.
Press (SCREEN) to turn to the Panorama/
Wall paper mode. Then the adjusted
panorama image is displayed.
Notes
• You can set the image format as follows:
JPEG: 1,600 1,200 dots or less
• You can set the display while the unit must be kept
on.
• You can preview up to 100 images from a folder
within a "Memory Stick" at one time.
• The following folders in a "Memory Stick" cannot be
displayed.
– CONTROL
– DCIM
– MSSONY
– VOICE
– HIFI
• In step 5 or 7, if there is no image data, "No Picture"
is shown in the display.
• Depending on the volume of stored data, the storing
time differs. Do not turn off the unit while the
message in step 10 is displayed. If you turn off the
power, the data will not be stored.
• If the capacity of the unit is not enough, "MEM FULL
– delete data" is displayed and you cannot store the
data. After deleting the data (page 39), perform the
settings again.
Tips
• You can store a maximum of 100 panorama images
in the unit.
• If "Cyber-shot" is selected in step 6, the folder is
selected automatically.