Sony MEX-5DI Installation/Connections

M G-M S/FM /AM
Compact Disc
Player
Inst allat ion/Connect ions
Inst allat ion/Connexions
Inst alación/Conexiones
M EX-5DI
Sony Corporation © 2002
1
121 (4
9.5 ( 3 / )
8
59 (2 3 / )
8
Unit: mm (in.)
Unité : mm (po.)
Unidad: mm
Dimensions include unit size, front panel and disc tray open, etc.
Les dimensions comprennent l'appareil lui-même, la façade et le plateau de disque lorsqu'ils sont
ouverts, etc.
Las dimensiones incluyen el tamaño de la unidad, el panel frontal y la bandeja de discos abierta, etc.
2
1
4 5
Equipm ent used in illust rat ions (not supplied)
Appareils ut ilisés dans les illust rat ions (non fournis)
Equipos ut ilizados en las ilust raciones (no sum inist rados)
Front speaker
Haut-parleur avant
Altavoz delantero
Rear speaker
Haut-parleur arrière
Altavoz trasero
Active subwoofer
Caisson de graves actif
Altavoz potenciador de graves activo
Downloaded from: https://www.usersmanualguide.com/
3-242-050-11 (1)
Printed in Japan
7 5
/ ) 142.5 (5 / )
8 8
19 ( 3 / )
4
170 (6 3 / )
4
2 3
× 4
6 7
Power amplifier
Amplificateur de puissance
Amplificador de potencia
CD/MD changer
Changeur de CD/MD
Cambiador de CD/MD
3 A
B
Caut ions
• This unit is designed for negative ground 12 V DC
operation only.
• Do not get the wires under a screw, or caught in
moving parts (e.g. seat railing).
• Before making connections, turn the car ignition
off to avoid short circuits.
• Connect the yellow and red power input leads
only after all other leads have been connected.
• Run all ground wires to a common ground
point.
• Be sure to insulate any loose unconnected wires
with electrical tape for safety.
• The use of optical instruments with this product
will increase eye hazard.
Notes on the power supply cord (yellow)
• When connecting this unit in combination with
other stereo components, the connected car
circuit's rating must be higher than the sum of
each component's fuse.
• When no car circuits are rated high enough,
connect the unit directly to the battery.
Before inst allat ion (1)
Do not install the unit where its operation interferes
with driving.
× 2
Example:
— Opening and closing of the front panel or disc
tray interfere with operation of the gear shift.
— With the front panel open, operation of hazard
lamps, switches etc., is impaired.
Part s Iist (2)
The numbers in the list are keyed to those in the
instructions.
For the use of release key 7, see the supplied
operating instructions.
Caut ion
Handle the bracket
1 carefully to avoid
injuring your fingers.
AUDIO OUT
SUB OUT (M ONO) FRONT
AUDIO OUT
REAR
BUS AUDIO IN
BUS CONTROL IN
BUS AUDIO IN
Source selector*
Sélecteur de source*
Selector de fuente*
XA-C30
BUS CONTROL IN
Connect ion exam ple (3)
Note (3-A)
Be sure t o connect t he ground cord bef ore connect ing
t he amplif ier.
Tip (3-B- )
For connect ing t w o or more CD/M D changers, t he source
select or XA-C30 (opt ional) is necessary.
Connect ion diagram (4)
1
To a metal surface of the car
First connect t he black ground lead, t hen connect
t he yellow and red pow er input leads.
2
To the power antenna control lead or power
supply lead of antenna booster amplifier
Notes
• It is not necessary t o connect t his lead if t here is no
pow er ant enna or ant enna boost er, or w it h a
manually-operat ed t elescopic ant enna.
• When your car has a built -in FM /AM ant enna in
t he rear/side glass, see " Not es on t he cont rol and
pow er supply leads."
3
To AMP REMOTE IN of an optional power
amplifier
This connect ion is only f or amplif iers. Connect ing
any ot her syst em may damage t he unit .
4
To the interface cable of a car telephone
5
To a car's illumination signal
Be sure t o connect t he black ground lead t o it f irst .
6
To the +12 V power terminal which is energized
in the accessory position of the ignition key
switch
Notes
• If t here is no accessory posit ion, connect t o t he +12
V pow er (bat t ery) t erminal w hich is energised at all
t imes.
Be sure t o connect t he black ground lead t o it f irst .
• When your car has a built -in FM /AM ant enna in
t he rear/side glass, see " Not es on t he cont rol and
pow er supply leads."
7
To the +12 V power terminal which is energised
at all times
Be sure t o connect t he black ground lead t o it f irst .
Notes on the control and pow er supply leads
• The pow er ant enna cont rol lead (blue) supplies +12 V
DC w hen you t urn on t he t uner.
• When your car has built -in FM /AM ant enna in t he rear/
side glass, connect t he pow er ant enna cont rol lead
(blue) or t he accessory pow er input lead (red) t o t he
pow er t erminal of t he exist ing ant enna boost er. For
det ails, consult your dealer.
• A pow er ant enna w it hout relay box cannot be used
w it h t his unit .
M emory hold connection
When t he yellow pow er input lead is connect ed, pow er
w ill alw ays be supplied t o t he memory circuit even w hen
t he ignit ion key is t urned of f .
* not supplied
non f ourni
no suminist rados