Valet Mode - Dodge Durango SRT 2018 Owner's Manual

To actuate the Shift Light feature, press the
"Shift Light" button on the touchscreen, then
press the "Shift Light On" button on the touch-
screen. Activation is shown on the instrument
cluster display. Pressing the "Shift Light RPM
Set-Up" button on the touchscreen will take you
to the Shift Light RPM Set-Up screen.
NOTE:
You must be in Paddle Shift Mode, or the
electronic-shifter must be in the M position, in
order to activate the shift light. Refer to "Auto-
matic Transmission" in "Starting And Operating"
for further information.
Shift Light RPM Set-Up
The Shift Light RPM Set-Up allows you to set
the shift light to illuminate for gears 1, 2, 3, 4,
and 5-8. Pressing and releasing the up/down
288
arrow buttons above and below each listed gear,
the RPM values will change in increments of
250 RPM. Pressing and holding the arrows will
change the RPM values in increments of
500 RPM, ranging from 6250 RPM. The Shift
Light setup screen may only be accessed if the
feature is enabled, press the "Reset to Factory
Default" button on the touchscreen to change
back to factory settings, or press the "Shift Light
Off" button on the touchscreen to turn the sys-
tem off completely.

VALET MODE

Valet Mode Activation
To enter Valet Mode press the "Valet" button on
the touchscreen and a popup screen will ask
you if you would like to enter Valet Mode, after
selecting "Yes" you will be asked to enter a four
digit PIN code. The PIN code is not set, so you
are free to select any four digit numeric combi-
nation that will be easy to remember.
While in Valet Mode the following vehicle con-
figurations are set and locked to prevent unau-
thorized modification:
• All-Wheel Drive is set to 50/50.
• Transmission locks out access to first gear
and up-shifts earlier than normal.
• Steering wheel paddle shifters are disabled.
• The Drive Mode interface is not available.
Pushing the SRT button on Selec-Track
switch will display the unlock keypad.
• The ESC Off button is disabled.
• The Launch Control button is disabled.
• Engine power is reduced.
Valet Mode Deactivation