Dodge Durango SRT 2018 Owner's Manual page 139

Pulling Down The Carpet Floor Panel To
Access Top Tether Strap
Tether Anchorages
LATCH-compatible child restraint systems will
be equipped with a rigid bar or a flexible strap on
each side. Each will have a hook or connector to
attach to the lower anchorage and a way to
tighten the connection to the anchorage.
Forward-facing child restraints and some rear-
facing child restraints will also be equipped with
a tether strap. The tether strap will have a hook
136
at the end to attach to the top tether anchorage
and a way to tighten the strap after it is attached
to the anchorage.
Center Seat LATCH — Five Or Seven
Second Row Passenger Seating Only
WARNING!
• Do not install a child restraint in the center
position using the LATCH system. This
position is not approved for installing child
seats using the LATCH attachments. You
must use the seat belt and tether anchor to
install a child seat in the center seating
position.
• Never use the same lower anchorage to
attach more than one child restraint.
Please refer to "To Install A LATCH-
Compatible Child Restraint" for typical in-
stallation instructions.
Vehicle With A Center Arm Rest Tether —
Five Or Seven Passenger Seating Only
For rear-facing child restraints secured in the
center seat position with the vehicle seat belts,
the rear center seat position has an armrest
tether that secures the arm rest in the upward
position.
1. To access the center seat arm rest tether,
first lower the arm rest. The tether is located
behind the armrest and hooked onto the
plastic seat backing.
Center Seat Position Arm Rest Tether
2. Pull down on the tether to unhook it from the
plastic seat backing.
Center Seat Position Arm Rest Tether
3. Raise the armrest and attach the tether hook
to the strap located on the front of the arm
rest.